Half and Half Plate

Request More Information

OVERVIEW

Half and Half Plate

MiTek’s new MTH18 is a full size plate with over 50% more engineering values in Shear and Compression categories and over 10% increase in tension.  Half and Half plates are the perfect solution for both the component manufacturer and the framer.

  • Higher design values in the same dimension plate as the BEH18 hinge.
  • Creates a strong, secure connection.
  • Replaces the long running and successful BEH18 plate for hinge trusses.
  • 18 gauge ASTMA653 galvanized steel.
  • Available as a half and half hinge – teeh on one side, nail holes on the other – MTHNH18.
  • MTH18 & MTHNH18 plates are in MiTek design software.
  • The MTH18 replaces the BEH18 which is discontinued. 
  • Installation is made easy because you have no loose parts, no extra trusses to build or handle, and no worries about oversized loads on high-pitched trusses.

CONNECTOR PLATES

Standard MT20

Our connector plates offer the best balance between nail value and steel strength in the industry.

Learn more

Learn more

Standard MT20

Learn more
Triple Zinc

Learn more

Learn more

Triple Zinc

Learn more
Stainless Steel MT20SS

Learn more

Learn more

Stainless Steel MT20SS

Learn more
M18HS

Learn more

Learn more

M18HS

Learn more
MII16

We use only the highest-grade steel for our connector plates.

Learn more

Learn more

MII16

Learn more
T-Plates

For manufacturing floor trusses, if forces are too high in a floor, use a T-Plate to handle pressure of top cord bearing.

Learn more

Learn more

T-Plates

Learn more
Hinge Plate

As a component manufacturer you only have one truss to build and as a framer you only have one truss to set!

Learn more

Learn more

Hinge Plate

Learn more
Half and Half

Learn more

Learn more

Half and Half

Learn more
Nail-On Plates

Our nail-on plates handle any repair. Use these instead of plywood.

Learn more

Learn more

Nail-On Plates

Learn more
Strip Plate

Learn more

Learn more

Strip Plate

Learn more